1. System requirements
    1.1. Which operating systems are supported by CRANE MANAGER V3.0 and 2011?
    1.2. Which CAD-systems are supported by CRANE MANAGER V3.0 and 2011?
    1.3. Is it possible to install and run CRANE MANAGER V3.0 on Windows 64 BIT operating systems?
    1.4. Is it possible to install and run CRANE MANAGER V3.0 on other platforms beside Windows?


2. Licensing
    2.1. The following Message appears: "Dongle not found - Software runs in DEMO Mode". What can I do?
    2.2. Is there a network license for CRANE MANAGER ?
    2.3. On how many computers can a CRANE MANAGER license be installed and used?
    2.4. What is a dongle?


3. CAD-Interface
    3.1. I get a "write permission denied" error while transferring data to CAD. What can I do?
    3.2. How can I pass over a crane to my CAD-system if the relevant Button is deactivated?
    3.3. While transfer from CRANE MANAGER to AutoCAD 2010 / 11 / 12 :
            Why is the crane not built up completely?
            Why is the transfer command interrupted and draws an unwanted line?
            Why can the present crane not be moved or is placed wrong?
    3.4. Why is the system so slow when a crane is loaded in AutoCAD?
    3.5. Why is the crane displayed in pale grayscale?


4. CAD
    4.1. Is there an easy-to-use manual for 3D CAD ?


5. Crane Manager
    5.1. Is there an easy-to-use manual for Crane Manager ?
    5.2. Is there an easy-to-use manual for the multilift funktion ?
    5.3. How can a CRANE MANAGER V3.0 project be used with CRANE MANAGER 2011 ?